Library

Arts

Cyanotype Printing

A pressed leaf, a scrap of lace or a paper cutout can become the subject of a photograph. Lay it on light-sensitive paper, expose the sheet to sunlight and rinse it to reveal a pale silhouette against blue.

photography botanical
Illustration of flower pressing
Hobby Portal illustration

Start with a silhouette

Pick a leaf you could recognise by its outline alone. Its serrated edge or forked stem will give you a detail to look for when the print dries. This kind of camera-free photograph is called a photogram. Pre-coated cyanotype paper lets you try it without mixing a solution or setting up a darkroom.

What to gather

Start with a small pack of pre-coated sheets, a stiff backing board, a clear acrylic pressing sheet, a shallow tray of water and an absorbent surface for drying. Check whether the pack includes the acrylic. Paper is the main repeat expense. Compare local packs by sheet size and count, especially if you want to make several small prints.

A tabletop with room for the board and rinse tray is enough for assembly and washing. Choose a sunny spot you can reach with the board held level. Set out the rinse water before opening the packet, and keep unused sheets closed in their lightproof wrapper.

Your first print

  1. Rehearse on plain paper. Place the leaf slightly off centre and leave an open margin so you can see how dark the exposed background becomes.
  2. Work indoors away from daylight. Lay one sheet on the board, coated side up. Transfer the leaf and lower the acrylic straight down to hold it still.
  3. Carry the board into sunlight. Follow your paper’s exposure cue and record the elapsed time and cloud cover. The time needed can change with the light.
  4. Bring the board back out of the sun, lift the leaf and rinse the paper as directed on the packet. Lay the print flat to dry. Judge the blue and the edge detail once the sheet is dry.

Frequently Asked Questions

Why is the stem sharp but the leaf tip looks fuzzy?

Look at the leaf edge-on. A curled tip leaves a gap where light can reach underneath. Try the same leaf after pressing it flat, keeping the exposure similar so you can compare the two tips.

Why did my paper cutout leave a blue double edge?

The cutout may have shifted during exposure. Assemble the print on a rigid board and keep the acrylic in place until you have carried the board back indoors.

My dry print is pale all over. What should I change?

Try a small exposure test. Place an opaque shape on each of two pieces from the same pack and set them out together. Bring one in at the packet’s suggested exposure and leave the second out a little longer. Rinse them alike and compare the exposed margins after drying.

Adapt the work surface

For seated printing, keep the board and a shallow, stable rinse tray within reach. A large paper shape with a cutout handle is easier to lift than a fine stem. If moving the board outdoors is awkward, one person can arrange the composition while a partner carries and times it. Use a dedicated craft tray, keep food away from the work surface, wash your hands afterwards and follow the paper maker’s handling and disposal instructions.

A first month in four short sessions
SessionWhat to tryWhat to look for
One leafMake one print and note the light and exposure time on the dry sheet's back.Find the smallest detail you can recognise in the outline.
One subject, two exposuresRepeat a simple shape on two small sheets in the same light, varying only the exposure time.Choose the blue you prefer once both sheets are dry.
OpenworkTry a scrap of lace or a paper cutout with holes of different sizes.Look for blue in the openings and check which fine gaps stayed distinct.
A series of threeMake three small prints with the same margins. Work solo or swap subjects with a friend.Lay them side by side and choose a spacing or shape you want to repeat.

Illustrated printing instructions